Works - DRGW MOW Water Car X2915 - 02 [Works_MOW Equipment]
: stripped end sill and applied stirrups
I started with stripping off the end sill, together with the stirrups. I added the new stirrups using the D type parts from BLMA with brass rod to represent the stay. A guide plate was required for me to bore the 16 holes just next to the edge of the sill.
: drawing for the water car stirrups
: BLMA parts I used
まず、台枠の端部をステップごと削った。BLMAから出ているステップのパーツと0.3ミリの真鍮線で、プロトタイプの2段ステップを再現した。
フレームの四隅ぎりぎりのところに穴を開けるのは、筆者には難しい工程だと考え、模型を実測して図面を作った。プリントアウトして穴開けのケガキ代わりとし、プラ板製のテンプレートに沿って真鍮線を曲げた。
I started with stripping off the end sill, together with the stirrups. I added the new stirrups using the D type parts from BLMA with brass rod to represent the stay. A guide plate was required for me to bore the 16 holes just next to the edge of the sill.
: drawing for the water car stirrups
: BLMA parts I used
まず、台枠の端部をステップごと削った。BLMAから出ているステップのパーツと0.3ミリの真鍮線で、プロトタイプの2段ステップを再現した。
フレームの四隅ぎりぎりのところに穴を開けるのは、筆者には難しい工程だと考え、模型を実測して図面を作った。プリントアウトして穴開けのケガキ代わりとし、プラ板製のテンプレートに沿って真鍮線を曲げた。
2010-06-05 14:00
コメント(0)
トラックバック(0)
コメント 0